DRV8824PWPR

Mfr. #:
DRV8824PWPR
Mfr.:
Texas Instruments
Product Type:
Stepper Motor Driver
Series:
DRV8824
Package / Case:
28-HTSSOP
Description:
45 V bipolar stepper motor driver, 1.6 A, 1/32 microstepping, 28-HTSSOP

Product Attributes

AttributeValue
Output Current1.6 A maximum at 24 V and TA = 25 °C with proper heatsinking
Control InterfaceSTEP/DIR with hardware mode pins
ProtectionOvercurrent, thermal shutdown and motor-supply undervoltage lockout
Operating Temperature−40 °C to +85 °C
Motor TypeBipolar stepper motor
Motor Supply Voltage8.2 V to 45 V
Full BridgesTwo integrated H bridges
MicrosteppingFull step through 1/32 step
Current RegulationFixed-frequency PWM using external sense resistors and xVREF
Decay ModesSlow, fast and mixed decay
Package DetailsPowerPAD™ PWP package, 4.4 × 9.7 mm body, 0.65 mm pitch

Product Details

DRV8824PWPR integrates two MOSFET H bridges and a microstep indexer for one bipolar stepper motor from an 8.2 V to 45 V motor supply. The stated 1.6 A maximum is specified at 24 V and 25 °C with proper heatsinking, so winding current, bridge losses, ambient temperature and the exposed-pad PCB thermal path determine the usable continuous operating point.

STEP and DIR commands advance the built-in indexer from full step through 1/32 step. Each winding's chopping threshold is set by its reference voltage and external sense resistor, and slow, fast or mixed decay determines how current falls between drive intervals. These choices jointly affect current tracking, torque ripple and acoustic behavior at the intended motor inductance and step rate.

Overcurrent, undervoltage and thermal faults disable drive and assert nFAULT, but they do not replace correct current scaling or thermal design. The 28-pin PowerPAD™ package must transfer heat into board copper, and firmware or control logic must provide the required reset or sleep sequence after a latched protection event.

Quality · Shipping · Payment

Details

Quality Confirmation

Pre-shipment checks cover batch, package, labels and markings. Inspection photos and third-party inspection support are available on request.

Shipping

Worldwide delivery is supported. Carrier, lead time and buyer-appointed forwarder requirements are confirmed with the quotation.

Payment

Payment method, currency and trade terms are subject to the formal quotation or proforma invoice.