DRV8714SQRHARQ1

Mfr. #:
DRV8714SQRHARQ1
Mfr.:
Texas Instruments
Product Type:
Half-Bridge Gate Driver
Series:
DRV8714S-Q1
Package / Case:
40-VQFN
Description:
Automotive four-channel smart half-bridge gate driver with dual current-sense amplifiers, 40-VQFN

Product Attributes

AttributeValue
Operating Temperature−40 °C to +125 °C
Gate-Driver ChannelsFour half bridges for external N-channel MOSFETs
Operating Supply4.9 V to 37 V, 40 V absolute maximum
InterfaceSPI with four PWM inputs and output mapping
Control ModesIndependent half bridge, H bridge and SPI-controlled modes
Gate-Drive Current50 µA to 62 mA programmable peak source and sink
Current-Sense AmplifiersTwo amplifiers supporting inline, high-side or low-side sensing
Amplifier Gain10, 20, 40 or 80 V/V
Gate ControlProgrammable slew rate, adaptive propagation delay and integrated dead-time handshaking
DiagnosticsMOSFET VDS overcurrent and VGS gate-fault monitoring, offline open-load/short diagnostics and watchdog
QualificationAEC-Q100 Grade 1
Package Details40-pin 6 × 6 mm VQFN (RHA) with wettable flanks, tape-and-reel order

Product Details

DRV8714SQRHARQ1 drives four external N-channel MOSFET half bridges, which can be arranged as independent loads or paired H bridges. The gate driver does not set the load-current rating by itself; MOSFET resistance, gate charge, switching rate, current path and board thermal design determine the power-stage limit.

Its two current-shunt amplifiers can measure inline, high-side or low-side shunts with selectable gains of 10, 20, 40 or 80 V/V. Inline placement preserves motor-current information during recirculation intervals, but the shunt range, common-mode path and amplifier output headroom must be matched to the controller ADC.

The S variant uses SPI to select drive current, slew behavior, dead time, protection response and diagnostic functions. Programmable gate drive can trade switching loss against EMI, while VDS, VGS, open-load, short-circuit and thermal monitors report distinct failure modes that firmware must interpret before retrying or disabling a load.

Quality · Shipping · Payment

Details

Quality Confirmation

Pre-shipment checks cover batch, package, labels and markings. Inspection photos and third-party inspection support are available on request.

Shipping

Worldwide delivery is supported. Carrier, lead time and buyer-appointed forwarder requirements are confirmed with the quotation.

Payment

Payment method, currency and trade terms are subject to the formal quotation or proforma invoice.