DRV8714SQRHARQ1

制造商型号:
DRV8714SQRHARQ1
制造商:
Texas Instruments
产品类型:
Half-Bridge Gate Driver
系列:
DRV8714S-Q1
封装:
40-VQFN
描述:
Automotive four-channel smart half-bridge gate driver with dual current-sense amplifiers, 40-VQFN

产品属性

属性数值
Operating Temperature−40 °C to +125 °C
Gate-Driver ChannelsFour half bridges for external N-channel MOSFETs
Operating Supply4.9 V to 37 V, 40 V absolute maximum
InterfaceSPI with four PWM inputs and output mapping
Control ModesIndependent half bridge, H bridge and SPI-controlled modes
Gate-Drive Current50 µA to 62 mA programmable peak source and sink
Current-Sense AmplifiersTwo amplifiers supporting inline, high-side or low-side sensing
Amplifier Gain10, 20, 40 or 80 V/V
Gate ControlProgrammable slew rate, adaptive propagation delay and integrated dead-time handshaking
DiagnosticsMOSFET VDS overcurrent and VGS gate-fault monitoring, offline open-load/short diagnostics and watchdog
QualificationAEC-Q100 Grade 1
Package Details40-pin 6 × 6 mm VQFN (RHA) with wettable flanks, tape-and-reel order

产品详细说明

DRV8714SQRHARQ1 drives four external N-channel MOSFET half bridges, which can be arranged as independent loads or paired H bridges. The gate driver does not set the load-current rating by itself; MOSFET resistance, gate charge, switching rate, current path and board thermal design determine the power-stage limit.

Its two current-shunt amplifiers can measure inline, high-side or low-side shunts with selectable gains of 10, 20, 40 or 80 V/V. Inline placement preserves motor-current information during recirculation intervals, but the shunt range, common-mode path and amplifier output headroom must be matched to the controller ADC.

The S variant uses SPI to select drive current, slew behavior, dead time, protection response and diagnostic functions. Programmable gate drive can trade switching loss against EMI, while VDS, VGS, open-load, short-circuit and thermal monitors report distinct failure modes that firmware must interpret before retrying or disabling a load.

质量 · 运输 · 付款

详情

质量确认

发货前核对批次、封装、标签及丝印。可按需提供验货照片,并协助第三方检验。

运输

支持全球交付。承运商、交期及买方指定货代要求,在报价时确认。

付款

付款方式、币种及贸易条款,以正式报价或形式发票为准。