24FC1025T-I/SN

Mfr. #:
24FC1025T-I/SN
Mfr.:
Microchip Technology
Product Type:
EEPROM
Series:
24FC1025
Package / Case:
8-SOIC
Description:
1 Mbit I2C EEPROM, 128K × 8, 1.8–5.5 V, up to 1 MHz at 2.5–5.5 V, 8-SOIC

Product Attributes

AttributeValue
Memory TypeNonvolatile EEPROM
InterfaceI2C-compatible two-wire serial
Clock Frequency1 MHz maximum at VCC = 2.5–5.5 V; 400 kHz maximum below 2.5 V
Page Size128 bytes; writes must remain within one physical page
Endurance1,000,000 cycles minimum at +25 °C, 5.5 V, page mode; endurance is specified per page
Supply Voltage1.8–5.5 V
Operating Temperature−40 °C to +85 °C, industrial I grade
Memory Size1 Mbit (1024 Kbit), 128K × 8
Write Cycle Time5 ms maximum, byte or page
Address OrganizationTwo 64K × 8 blocks; control-byte B0 selects address bit A16
Read ModesCurrent-address, random and sequential; sequential reads wrap within a 64K-byte block
Bus ExpansionUp to 4 devices using A0 and A1 chip-select pins
A2 PinMust be tied to VCC
Write ProtectionWP high protects the entire array; reads remain available
Package DetailsSN narrow-body SOIC, 8 leads, 3.90 mm body width

Product Details

24FC1025T-I/SN stores configuration or calibration data in a 1 Mbit nonvolatile I2C EEPROM. Its 128K-byte array is divided into two 64K-byte blocks selected by B0 in the control byte. Sequential reads wrap inside the selected block, so software must start another transaction to cross that boundary.

The 128-byte page buffer groups updates into one internal write cycle lasting up to 5 ms. Firmware must split writes at physical page boundaries because excess bytes wrap to the start of the same page. ACK polling determines when programming has finished. Even a short write refreshes the whole page, making update distribution relevant to the specified per-page endurance.

The FC version supports a 1 MHz bus at 2.5–5.5 V and up to 400 kHz at lower supported voltages. A0 and A1 allow four devices on one bus, while A2 must be tied to VCC for operation. Driving WP high protects the complete array while preserving read access, allowing stored settings to be locked after programming.

Quality · Shipping · Payment

Details

Quality Confirmation

Pre-shipment checks cover batch, package, labels and markings. Inspection photos and third-party inspection support are available on request.

Shipping

Worldwide delivery is supported. Carrier, lead time and buyer-appointed forwarder requirements are confirmed with the quotation.

Payment

Payment method, currency and trade terms are subject to the formal quotation or proforma invoice.