24FC1025T-I/SN

制造商型号:
24FC1025T-I/SN
制造商:
Microchip Technology
产品类型:
EEPROM
系列:
24FC1025
封装:
8-SOIC
描述:
1 Mbit I2C EEPROM, 128K × 8, 1.8–5.5 V, up to 1 MHz at 2.5–5.5 V, 8-SOIC

产品属性

属性数值
Memory TypeNonvolatile EEPROM
InterfaceI2C-compatible two-wire serial
Clock Frequency1 MHz maximum at VCC = 2.5–5.5 V; 400 kHz maximum below 2.5 V
Page Size128 bytes; writes must remain within one physical page
Endurance1,000,000 cycles minimum at +25 °C, 5.5 V, page mode; endurance is specified per page
Supply Voltage1.8–5.5 V
Operating Temperature−40 °C to +85 °C, industrial I grade
Memory Size1 Mbit (1024 Kbit), 128K × 8
Write Cycle Time5 ms maximum, byte or page
Address OrganizationTwo 64K × 8 blocks; control-byte B0 selects address bit A16
Read ModesCurrent-address, random and sequential; sequential reads wrap within a 64K-byte block
Bus ExpansionUp to 4 devices using A0 and A1 chip-select pins
A2 PinMust be tied to VCC
Write ProtectionWP high protects the entire array; reads remain available
Package DetailsSN narrow-body SOIC, 8 leads, 3.90 mm body width

产品详细说明

24FC1025T-I/SN stores configuration or calibration data in a 1 Mbit nonvolatile I2C EEPROM. Its 128K-byte array is divided into two 64K-byte blocks selected by B0 in the control byte. Sequential reads wrap inside the selected block, so software must start another transaction to cross that boundary.

The 128-byte page buffer groups updates into one internal write cycle lasting up to 5 ms. Firmware must split writes at physical page boundaries because excess bytes wrap to the start of the same page. ACK polling determines when programming has finished. Even a short write refreshes the whole page, making update distribution relevant to the specified per-page endurance.

The FC version supports a 1 MHz bus at 2.5–5.5 V and up to 400 kHz at lower supported voltages. A0 and A1 allow four devices on one bus, while A2 must be tied to VCC for operation. Driving WP high protects the complete array while preserving read access, allowing stored settings to be locked after programming.

质量 · 运输 · 付款

详情

质量确认

发货前核对批次、封装、标签及丝印。可按需提供验货照片,并协助第三方检验。

运输

支持全球交付。承运商、交期及买方指定货代要求,在报价时确认。

付款

付款方式、币种及贸易条款,以正式报价或形式发票为准。