DRV8889AQWRGERQ1

Mfr. #:
DRV8889AQWRGERQ1
Mfr.:
Texas Instruments
Product Type:
Stepper Motor Driver
Series:
DRV8889A-Q1
Package / Case:
24-VQFN
Description:
Automotive bipolar stepper motor driver, 1.5 A full-scale, 1/256 microstepping, 24-VQFN

Product Attributes

AttributeValue
Output Current1.5 A full-scale; 2.4 A peak per bridge
Control InterfaceSTEP/DIR and 4-wire SPI with daisy-chain support
Operating Temperature−40 °C to +125 °C
Motor TypeBipolar stepper motor
Operating Supply4.5 V to 45 V
MicrosteppingUp to 1/256 step
Current SensingIntegrated current sensing; external sense resistors not required
Bridge Resistance900 mΩ typical high-side plus low-side at 25 °C
Decay ControlSmart tune, slow and mixed decay options
Sleep Current2 µA typical
QualificationAEC-Q100 automotive qualified
Package Details24-pin VQFN (RGE), tape-and-reel order

Product Details

DRV8889AQWRGERQ1 integrates the two H bridges, microstep indexer and current regulation needed for one bipolar stepper motor. Its 1.5 A full-scale value sets the regulated winding-current range, while the 2.4 A peak figure is not a continuous thermal rating; winding current, bridge loss, PCB copper and ambient temperature determine the usable operating point.

The indexer supports steps down to 1/256, and the decay engine can select smart-tune, slow or mixed behavior while integrated current sensing removes the two external shunt resistors. Microstep resolution, current scaling and decay settings jointly affect torque ripple, acoustic behavior and current settling at the commanded step rate.

STEP/DIR provides the motion command while SPI configures current scaling, slew rate, diagnostics and daisy-chained devices. Stall, open-load, overcurrent and thermal reports still require firmware policy; the A variant adds programmable open-load timing, which must be set for the motor and decay conditions rather than treated as an unconditional fault threshold.

Quality · Shipping · Payment

Details

Quality Confirmation

Pre-shipment checks cover batch, package, labels and markings. Inspection photos and third-party inspection support are available on request.

Shipping

Worldwide delivery is supported. Carrier, lead time and buyer-appointed forwarder requirements are confirmed with the quotation.

Payment

Payment method, currency and trade terms are subject to the formal quotation or proforma invoice.