DRV8889AQWRGERQ1

制造商型号:
DRV8889AQWRGERQ1
制造商:
Texas Instruments
产品类型:
Stepper Motor Driver
系列:
DRV8889A-Q1
封装:
24-VQFN
描述:
Automotive bipolar stepper motor driver, 1.5 A full-scale, 1/256 microstepping, 24-VQFN

产品属性

属性数值
Output Current1.5 A full-scale; 2.4 A peak per bridge
Control InterfaceSTEP/DIR and 4-wire SPI with daisy-chain support
Operating Temperature−40 °C to +125 °C
Motor TypeBipolar stepper motor
Operating Supply4.5 V to 45 V
MicrosteppingUp to 1/256 step
Current SensingIntegrated current sensing; external sense resistors not required
Bridge Resistance900 mΩ typical high-side plus low-side at 25 °C
Decay ControlSmart tune, slow and mixed decay options
Sleep Current2 µA typical
QualificationAEC-Q100 automotive qualified
Package Details24-pin VQFN (RGE), tape-and-reel order

产品详细说明

DRV8889AQWRGERQ1 integrates the two H bridges, microstep indexer and current regulation needed for one bipolar stepper motor. Its 1.5 A full-scale value sets the regulated winding-current range, while the 2.4 A peak figure is not a continuous thermal rating; winding current, bridge loss, PCB copper and ambient temperature determine the usable operating point.

The indexer supports steps down to 1/256, and the decay engine can select smart-tune, slow or mixed behavior while integrated current sensing removes the two external shunt resistors. Microstep resolution, current scaling and decay settings jointly affect torque ripple, acoustic behavior and current settling at the commanded step rate.

STEP/DIR provides the motion command while SPI configures current scaling, slew rate, diagnostics and daisy-chained devices. Stall, open-load, overcurrent and thermal reports still require firmware policy; the A variant adds programmable open-load timing, which must be set for the motor and decay conditions rather than treated as an unconditional fault threshold.

质量 · 运输 · 付款

详情

质量确认

发货前核对批次、封装、标签及丝印。可按需提供验货照片,并协助第三方检验。

运输

支持全球交付。承运商、交期及买方指定货代要求,在报价时确认。

付款

付款方式、币种及贸易条款,以正式报价或形式发票为准。