TPS610981DSER

Mfr. #:
TPS610981DSER
Mfr.:
Texas Instruments
Product Type:
Synchronous Boost Converter with LDO
Series:
TPS61098x
Package / Case:
6-WSON
Description:
3.3 V synchronous boost converter with 3.0 V LDO, 0.7–4.5 V input, 6-WSON

Product Attributes

AttributeValue
Input Voltage0.7 V to 4.5 V
Quiescent Current300 nA typical in low-power mode
EfficiencyUp to 88% at 10 µA and up to 93% at 5–100 mA, both for 2 V to 3.3 V conversion
Operating Temperature−40 °C to +125 °C junction
Boost OutputVMAIN = 3.3 V in active and low-power modes
LDO OutputVSUB = 3.0 V in active mode; off with active discharge in low-power mode
Switch Peak Current Limit350 mA minimum
Output CapabilityUp to 50 mA total output at 0.7 V input to 3.3 V output
Operating ModesActive mode and low-power mode selected by MODE input
Package Details6-pin WSON (DSE), 1.5 × 1.5 mm body

Product Details

TPS610981DSER combines a synchronous boost converter with a 3.0 V LDO to derive two rails from a low-voltage battery. Its VMAIN rail remains regulated at 3.3 V in active and low-power modes, while VSUB is available at 3.0 V only in active mode. Pulling MODE low turns the peripheral rail off with active discharge while leaving the main rail available at a typical 300 nA quiescent current.

The converter can start into a load from 0.7 V and operates to 4.5 V. Its 350 mA minimum switch peak-current limit is an inductor-current boundary, not a guaranteed load-current rating; the data sheet specifies up to 50 mA total output for the demanding 0.7 V to 3.3 V conversion. Battery voltage, conversion ratio, inductor ripple and the load split between VMAIN and VSUB therefore determine usable current.

Automatic pass-through stops switching when the input rises above the main-rail threshold and conducts the input to VMAIN. This behavior reduces conversion loss but means the rail is no longer held to the boost setpoint in pass-through, so downstream voltage limits must cover the permitted input range.

Quality · Shipping · Payment

Details

Quality Confirmation

Pre-shipment checks cover batch, package, labels and markings. Inspection photos and third-party inspection support are available on request.

Shipping

Worldwide delivery is supported. Carrier, lead time and buyer-appointed forwarder requirements are confirmed with the quotation.

Payment

Payment method, currency and trade terms are subject to the formal quotation or proforma invoice.